Here is my water prep setup. . .

Attachments:

I can, and I will, later on this week.

Well, I am getting a good feeling from the process, maybe a smaller sense of energy from the water. I am more going on physical indicators that the water is progressing to the stage that I can transfer it to my vehicle. The physical indicators that I have seen in the videos. I will keep charging it until I feel I can transfer it to my other cell.

I am currently charging 6 times/day, for 3 minutes, using ~1 amp of power, +-100ma. Any tips on how often to filter the water?

I am preparing some water and using currently recommended charging times, I believe. 6 times/day, 3 minutes/charging session, using ~1 amp (+-100ma).

I picked up some spring water off a mountain and charging is now where it should be, 12 volts @ 1 amp. Much easier to get the amperage. Filtered the water once and been thinking of running it through activated charcoal next time, to clean it up even more. There is some little bubbles forming, an insignificant amount, yet, there is some.

I figured there may be a problem with that mostly unadulterated water. I filtered the water last night and the amperage went down to ~2-3ma. I know where there is some pretty fantastic water, for drinking. I will get some of it and use it instead of deionized water. Until I *do* get it, I will continue to try charging the current water. … Read more

I am using structured, deionized, water and the variac is cranked up to at least 120 volts going into the Bridge rectifier. I’m unsure exactly how many volts out of the bridge rectifier, but the amps is less than 300 milliamps. I am guessing there is resistance.

Potassium chloride. . . . .check.

Is it still OK to us baking soda to increase amperage to water. Currently I have the variac cranked way up and getting <300ma. I read some information about using baking soda to increase amperage, and it was 4 years old. Just verifying it is OK to use baking soda.

Shane.

Is the 2″ sphere also isolated from the threaded rod, along with all the rest of the spheres, in both the charging and the car cells, leaving just the bismuth core hooked up to the negative side of the power source? I am currently getting the charging cell hemispheres drilled at the university. I just finished watching a video and it looks… Read more

Alrighty. I managed to pick up a couple different kinds of capacitors:

-140000uf 40v – I figure I can use this one, being careful to avoid exceeding 40v from the variac.
-820uf 200v – overkill but….. 😉

I now have all the components to get started making some water. Now, I just have to clean up one of the moejoe cells and… Read more

“A cut plant will have a much longer life span in a vase if a ground wire is added to it, because it will simulate a similar grounded/Earth connected environment for the plant to live in and allows for an electrical connection that the plant needs to live!”

Well, this is new information to me!! Thanks Bryce.

Thanks Moshe. I am going to see if I can get one in town today.

quote :That’s good that you left them alone. There have been some attempted tweaks but mostly just leaving trouble after with the sensors and not much for results.
What info are you referring to though?

The other info was just using the Moe-Joe cell with no modifications to the vehicle.

quote :Now we have to troubleshoot.
Can you take… Read more

What kind of success did the VOLO produce for you, Moshe? I see no report of findings in this thread.