[Nancy Fimbres]

thank you for clarifying the pos and neg leads positions. I watched a video with the moejoe in a glass container with the two posts(I say one and two posts because when i look at the moejoe from one side I see two posts and the other side has one post)anyway, the video I watched may have had the center and outer posts facing down in the glass jar because the positive lead was clearly on only post on top. which would have to be the center post and I thought the center post was drilled through the glass jar and the glass somehow shielded it so the negative lead could be clamped to the bottom of the center post that stuck through the glass.

Some of the videos do not have great resolution and no complete explanation of the set up because they are short videos and maybe only are looking at a specific thing like bubble formation and movement. I see that there is a lot of room for different set up and experimentation with the number of spheres, volts, current, water, additives and polarity.

maybe a better question would be what NOT TO DO. when someone says they ruined their moejoe, fried, burned, \”moejoe was never the same\”…what is meant by that and what causes that? so I know not to do that….(like putting the + and – on the center post….even if it is on the other side of the glass. lol)

\”what is current? what kind of water?\”

I have about half amp of current. I have the 2 12v batteries available but as of yet have only hooked up one at a time. the water I used was from those 30 cent a gallon reverse osmosis machines that are outside grocery stores. for drinking, I start with that 30 cents/gallon water then I run it through a zero filter system. comes with a ppm meter so you can see it takes out all particulates including fluoride. so I took that twice filtered water then I swirled it in a vortexer I made. two glass (mickeys)40 ounce green bottles connected with one of those tornado in a jar deals that I put magnets on in n/s/n/s configuration AND a tensor ring that I made…thats the water I have in there now, but there is no action so far, just some air bubbles that are forming and sticking to the glass.

lets say that I decide to switch the leads position/polarity on not even stage 1 water. is it ok to switch around the leads or do i have to start with brand new water or just filter it?

\”earth ground…What did they say in their post?\”

…they didn\’t. only mentioned that it was very good for plants and made them last longer in a vase. it was something they were going to try but no set up details. I think the plant/vase set up would have to be making contact with the water so I think I will start there after I have the basics down and can charge up my water ok.

I heard somewhere that the first charge goes more smoothly if you run it for a bit with 3amps current. am I making things hard on myself with my 12v battery setup? I am trying to do this the easiest and fastest way. after my sweet mother recovers from surgery, I will have more time to experiment. thank you for your advice and thoughtfulness, moshe…